Vertical Tension
& Controller
Model : VTC 5/20
Automatic tensioning and controlling for circular saw blades at same machine. Possible
diameter is from 500mm to 2,000mm. The shank should be vertically loaded and unloaded on
the machine and tensioning and controlling at the same conditions without removing shank
tension checking and tensioning carried out on the same spindle. |
  |
Main Features
- It consists of a table with a control spindle mounted on precision bearing with
precision flange.
- The pneumatic piston with constant unidirectional trust, is controlled and movement of
the transducer and plotting unit trolley.
- Shank locking by hydraulic system.
- Slope angle of two roller could be adjusted.
- Automatic shank rotation or manual shank rotation and automatic checking of tensioning.
- Non contact linear sensor able to check deflection within 0.01mm
- Fully computerised system allows creating & visualizing tension graphics and
deviation
- All technical data of tension & control could be stored on hard disk or floppy disk.
| Technical Data |
| Model No. |
VTC 5/20 |
| Power Supply |
380Volt 60 Hz
|
| (Different Voltage and Frequencies on request) |
| Power consumption |
5KW |
| Adjustable Pressure Force |
400Kg to 10,000Kg |
| Tension angle change |
3 degree max. |
| Roll speed |
15m/min variable |
| Roller radius |
55mm |
| Tension control pushing force |
5Kg to 30Kg |
| Shank rotation |
0-30RPM |
| Overall dimensions |
Length 3,000mm
Width 1,400mm
Height 1,750mm |
| Weight(indicative) |
2,400Kg |
| |
| Note : Special Modification could be
made by manufacturer upon request. |
|
